Testing The Slip And Receipt Stations - NCR 7156 Owner's Manual

Chapter 4: Diagnostics
Exit the Data Scope Mode
1.
Switch 7 is always Off. Switch 8: On = knife, Off = non-
knife
Switch
1
On
2.
3.
4.

Testing the Slip and Receipt Stations

These functions allow you to select various tests to check slip and receipt printing. It is the
only way to run the print test on the slip station. You can also run a print test on the receipt
station without changing the DIP switches by following the procedures in "Print Test" later
in this chapter.
Print Sample Check Via Feed Button
This test prints a sample check. Because blank checks are not all laid out the same, the
information may not line up perfectly on the blank check you use.
Caution: The DIP switches are pre-set at the factory and should generally not be changed.
If you must change them, do so carefully to avoid changing other functions.
Note: The operator panel may differ depending on the model. To put the printer on- or
off-line, use a paper clip or other pointed object to depress the plunger (in place of the On
Line button) on models with that item.
1.
Switch 7 is always Off. Switch 8: On = knife, Off = non-
knife
Switch
1
On
2.
44
Open the front cover and set the DIP switches to the following settings:
Switch Switch
2 3
Off Off
Close the front cover and press the On Line button (or plunger) to put the printer off-
line.
The green LED flashes when the printer cycles. The settings are entered into EEROM.
Set the DIP switches back to the settings for normal operation (on-line mode).
See "Switch Settings" in "Chapter 5: Communication" for the settings.
Close the front cover and press the On Line button (or plunger) to put the printer on-
line.
The green LED flashes when the printer cycles. The settings are entered into EEROM.
The printer will now communicate normally with the host computer.
Open the front cover and set the DIP switches to the following settings:
Switch Switch
2 3
Off Off
Close the front cover and press the On Line button (or plunger).
The green LED flashes when the printer cycles. The settings are entered into EEROM.
Switch Switch Switch
4 5 6
On Off Off
Switch Switch Switch
4 5 6
Off Off Off
September 1997
7156 Owner's Guide