Installing The Remote Control Devices - TOHATSU MFS 25B Owner's Manual

18 INSTALLATION

2. Installing the remote control devices

!
1
When using other than Tohatsu's genuine
remote control box, DO NOT select the
2
one without neutral safety switch that
prevents in-gear start.
Use of remote control box without neutral
safety switch can allow start of engine with
3
gear at other than neutral shift, potentially
leading passengers to falling or causing
passenger to be thrown overboard.
4
It is recommended that you consult
w i t h y o u r a u t h o r i z e d d e a l e r f o r
5
installation and adjustment of the
remote control device.
6
■ Installation of the Remote Control
Cables (Box side) :
7
Follow the instruction manual
provided with the remote control.
8
■ Installation of the Remote Control
on your boat :
9 Follow the instruction manual
provided with the remote control.
10
■ Installation of the Remote Control
Cable (engine side) and the Cord
Assembly (Wiring Harness) :
11
① Fitting of connecting parts to cables
12
Screw the tip of the remote control
cable into the cable joint up to
approx. 10 mm (0.39 inch), then lock
13
them with a lock nut. Apply grease to
the hole of the cable joint.
14
WARNING
Lock nut
Remoto control cable
② Fitting of Remote Control Cable to
Engine
Note
Put the control lever in the Neutral
position and the Free Accel lever in
the fully closed position.
S
T
S
T
T
S
CAUTION
!
Be careful not to loop the remote
control cables to a diameter of 406 mm
(16 inches) or less.
Cable joint
Approx. 10mm
(0.39 inch)
S
T
Shift Cable
Throttle Cable
Cable Harness B