26
ENGINE OPERATION
Before starting
Before starting engine for the first time
1
after reassembling engine or off-season
storage, disconnect stop switch lock
and pull the starter handle completely
2
out approximately 10 times in order to
prime the oil pump.
3
1. Starting
4
!
In case engine starts in gear, do not start
cruising. Stop engine immediately and
5
consult an authorized dealer.
6
Note
The engine will not start unless
7
the switch lock has been properly
connected into the emergency stop
switch.
8
!
9
Do not operate the engine with gear
case out of water.
Severe personal injury, or engine
10
damage will result.
① Loosen the air vent screw on the
11
tank cap.
12
13
14
WARNING
WARNING
Air Vent Screw
② Attach the fuel connector to the
engine connector.
The arrow mark on the primer bulb
should be facing the engine.
Fuel Connector
③ F e e d f u e l t o t h e e n g i n e b y
squeezing the primer bulb until it
is firm.
Engine side
④ Be sure to install the stop switch
lock to the stop switch.
Stop Switch Lock
Stop Switch Lock
Fuel tank side