Hitachi SJ200 Series Instruction Manual page 239

The following table lists the holding registers for the "A" Group Standard Functions.
Holding Registers for "A" Group Standard Functions
Func.
Name
Code
A001 Frequency source
setting
A002 Run command source
setting
A003 Base frequency setting
A203 Base frequency setting,
2nd motor
A004 Maximum frequency
setting
A204 Maximum frequency
setting, 2nd motor
A005 [AT] selection
A011 Pot./O–L input active
range start frequency
A012 Pot./O–L input active
range end frequency
A013 Pot./O–L input active
range start voltage
A014 Pot./O–L input active
range end voltage
R/W Description
R/W Five options; select codes:
00... Keypad potentiometer
01... Control terminal
02... Function F001 setting
03... ModBus network input
10... Calculate function output
R/W Three options; select codes:
01... Control terminal
02... Run key on keypad, or
digital operator
03... ModBus network input
R/W Settable from 30 Hz to the
maximum frequency
R/W Settable from 30 Hz to the 2nd
maximum frequency
R/W Settable from the base
frequency up to 400 Hz
R/W Settable from the 2nd base
frequency up to 400 Hz
R/W Four options, select codes:
00... Select between [O] and
[OI] at [AT]
01... [O] + [OI] ([AT] input is
ignored)
02... Select between [O] and
keypad potentiometer
03... Select between [OI] and
keypad potentiometer
R/W The output frequency corre-
sponding to the analog input
range starting point,
range is 0.0 to 400.0
R/W The output frequency corre-
sponding to the analog input
range ending point,
range is 0.0 to 400.0
R/W The starting point (offset) for
the active analog input range,
range is 0. to 100
R/W The ending point (offset) for
the active analog input range,
range is 0. to 100.
B–25
SJ200 Inverter
Network Data
Reg. Range Res.
002Dh 0 to 3, 10 —
002Eh 1, 2, 3 —
002Fh 30 to 1 Hz
max. freq.
0030h 30 to 1 Hz
max. freq.
2
0031h 30 to 400 1 Hz
0032h 30 to 400 1 Hz
0033h 0, 1, 2, 3 —
0034h 0 to 4000 0.1 Hz
0035h 0 to 4000 0.1 Hz
0036h 0 to 100 1 %
0037h 0 to 100 1 %