Hitachi SJ200 Series Instruction Manual page 251

Func.
Name
Code
C041 Overload level setting
C042 Frequency arrival
setting for acceleration
C043 Arrival frequency
setting for deceleration
C044 PID deviation level
setting
C052 PID FBV function high
limit
C053 PID FBV function low
limit
C071 Communication speed
selection
C072 Node allocation
C074 Communication parity
selection
C075 Communication stop bit
selection
C076 Communication error
select
C077 Communication error
time-out
C078 Communication wait
time
C081 O input span calibration R/W Scale factor between the
"C" Group Intelligent Terminal Functions
R/W Description
R/W Sets the overload signal level
between 0% and 200% (from 0
to two times the rated current
of the inverter)
R/W Sets the frequency arrival
setting threshold for the output
frequency during acceleration,
range is 0.0 to 400.0 Hz
R/W Sets the frequency arrival
setting threshold for the output
frequency during deceleration,
range is 0.0 to 400.0 Hz
R/W Sets the allowable PID loop
error magnitude (absolute
value), SP - PV, range is 0.0 to
100%, resolution is 0.1%
R/W When the PV exceeds this
value, the PID loop turns OFF
the PID Second Stage Output,
range is 0.0 to 100.0%
R/W When the PV goes below this
value, the PID loop turns ON
the PID Second Stage Output,
range is 0.0 to 100.0%
—
—
—
NOTE: These network settings
are not accessible to ModBus.
—
Use the inverter keypad or
digital operator to edit. Refer to
"Network Communication
—
Settings" on page 3–50
—
—
external frequency command
on terminals L – O (voltage
input) and the frequency
output, range is 0.0 to 200.0%
SJ200 Inverter
Network Data
Reg. Range
00BBh 0 to
20000
00BCh 0 to 4000
*1
00BDh 0 to 4000
00BEh 0 to 1000
00EAh 0 to 1000
00EBh 0 to 1000
00C0h —
00C1h —
00C3h —
00C4h —
00ECh —
.
00EDh —
00C5h —
00C7h 0 to 2000
B–37
Res.
0.01 %
0.1 Hz
0.1 Hz
0.1 %
0.1 %
0.1 %
—
—
—
—
—
—
—
0.1 %