Frame Submenu - Lab.gruppen PLM series Operation Manual

Front Panel Interface
Adjustment of attenuation at the input to the PLM power stage is available on a per-channel basis. This
adjustment is the PLM equivalent of a conventional amplifier level control. The power output channels may
be turned down using these parameters before powering on or off. Please refer to the signal flow diagram
in Figure 6-2 on page 27.
By default, all channels are deselected. Press the SEL ALL button to select/deselect all channels (as shown
in Figure 7-15) or, press a single button on the right to adjust a channel individually.
For four-channel PLMs, only ONE channel or ALL
channels may be adjusted. It is not possible to
adjust only two or three channels.
7.11.5

Frame Submenu

MENU > FRAME
The Frame Menu provides information and options relating to the PLM as a physical unit. It is referred to as
a Frame for consistency with Lake Controller terminology.
The Frame Label as defined in the Lake Controller is displayed in this menu. It is also displayed at the
top-left of the screen in Meter Mode, Home View.
7.11.5.1 Frame Info
MENU > FRAME > FRAME INFO
Frame Info provides information about the device settings and configuration. All data in this front panel
menu is read-only; some parameters are fixed, some can be changed only via the Lake Controller software.
54
PLM Series Operation Manual rev 1.1.9
Figure 7-16: Frame Menu