Rj45 Ethercon ® Network Connections - Lab.gruppen PLM series Operation Manual

Back Panel Interface
8.4 RJ45 etherCON
Two RJ45 etherCON style network connections are provided as shown in Figure 8-13.
The network connections auto-sense whether standard or crossover Cat-5e cables are in use. Pre-made
cables with moulded RJ45 plugs are recommended. If it is necessary to make up custom Cat-5e network
cables, use pinout described in Table 8-3.
When the device is connected to an active network, the yellow LINK LED illuminates above the connector in
use. Data activity on the network is indicated by illumination of the green ACT LED. It is normal for the ACT
LED to flicker either sporadically or continuously.
68
PLM Series Operation Manual rev 1.1.9
Network Connections
®
ACT PRIM LINK ACT
SWITCHED 100/1000 Base-T
Figure 8-13: etherCON Network Connectors
Pin No. Color
1 Brown
2 Brown + White
3 Green
4 Blue + White
5 Blue
6 Green + White
7 Orange
8 Orange + White
Table 8-3: RJ45 Wiring & Pin Out Description
Figure 8-14: RJ45 Wiring and Pin Out Diagram
SEC LINK