Table of Contents
Advertisement
5 Fax
Help 4 · Fax
Press î and 4 to print the instructions for sending
faxes and for fax switch settings.
Loading Documents
Do not insert any documents into the machine that
...
... are wet, have been edited with correction fluid, are
soiled or have a coated surface.
... are written on with a soft pencil, with paint, chalk
or charcoal.
... originate from newspapers or magazines (printing
ink).
... are held together with office or notebook staples or
with tape or glue.
... are pasted with note papers.
... are creased, crumpled or torn.
10 Documents · A5/A4
Use documents with sizes A5 or A4 with 60 to 100 g/m
weight. You can insert up to 10 documents at a time.
Cancel Transmission
Press j to eject the documents without sending them.
Sending fax
1 Insert the additional document holder on the docu-
ment feeder.
2 Insert the documents face up into the document feeder.
The top most document will be fed in first.
3 Then configure the desired resolution. You can choose be-
tween RESOL.: STANDARD (for documents without
special features), RESOL.: FINE (for texts with small
print or drawings) and RESOL.: PHOTO (for photos).
Press RES. The configured resolution appears on the dis-
play. Press RES again to change the resolution.
You can adjust the default contrast (see also sec-
tion Settings, page 30).
4 Dial the desired telephone number. There are multiple
ways to do this.
5 Press o.
Busy Number
If the subscriber is busy, the device dials the number
again after some time. Press j, in order to cancel the
transmission process. After the transmission, the ma-
chine prints out a transmission report depending on
the settings.
Manual dialling: Dial the desired telephone number
with the number pad.
2
Telephone book:
1 Press m
You can also load telephone book entries by
pressing OK, 11 and OK.
2 Use [ to select an entry. Enter the initial letters with
the number buttons to navigate more quickly in the tel-
ephone book.
You can save an entry multiple times with the
same name but in a different category. In the tel-
ephone book, the first letter of the category ap-
pears after the entry.
Short dial: Press Ý. Select the desired entry with [
or the number button.
Loading a Short Dial Entry
You can also load short dial entries by holding the re-
spective number button pressed (for at least two sec-
onds).
Redial list: Press @. Use [ to select an entry from the
list of dialled numbers.
Outgoing Calls
You can also load the redial list by pressing OK,
22 and OK.
Caller list: Hold @ pressed (for at least two seconds).
Use the [ to select an entry from the list of callers.
Calls Received
You can also load the caller list by pressing OK,
21 and OK.
CLIP Prerequisite
For this function to work, the caller line identifica-
tion (CLIP) must be activated for your telephone
connection (country and network dependent). The
number and name will not be shown if the caller sup-
presses his number.
Manually Sending a Fax
1 Insert the document.
2 Press l.
3 Enter the desired telephone number with the number
pad or select a saved entry.
4 Press o.
21
Advertisement
Table of Contents
