Powering On The System; Before Applying Power; Applying Power - High End Systems Roadster Orbital Head System User Manual

CHAPTER 2
Setup and Configuration
To connect the Roadster Orbital Head to a DMX link:
1. Connect the male XLR connector of a DMX data cable to the controller's DMX 'data out'
connector.
2. Connect the Data cable's female XLR connector to the 'data in' connector of the first (or
next) unit on the DMX link.
system.
Daisy-chaining Power Hubs in a DMX 512 link
3. Continue linking the remaining fixtures connecting a cable from the 'data out' (data thru)
connector of each fixture to the 'data in' connector of the next fixture on the link.
4. Connect a male terminator to the 'data out' connector of the last fixture in the link.

Powering On the System

Warnings: Connect this equipment only to a branch circuit having a
Caution: Do not power on the fixture until verifying that the line cord

Before Applying Power

• Manually rotate the Mirror Head, checking that it can move freely on both axes without
hitting the projector or any rigging hardware.
• Ensure that all cables, set pieces etc. are clear of the equipment.
• Keep all clothing and body parts clear of the equipment.
• Ensure that the equipment may not be accessed by the public or unqualified persons.

Applying Power

Caution: Keep hands free from the Mirror Head when powering up
14
This connection is on the Power hub for the Orbital Head
maximum overload protection of 20 A.
The Mirror Head moves under remote control, and is
designed for use by proficient technicians in a professional
environment.
cap is suitable for the power source in your location.
Keep hands free from the Mirror Head when powering up
the system to avoid a pinching hazard as the Mirror Head
begins to move during automatic homing.
the system to avoid a pinching hazard as the Mirror Head
begins to move during automatic homing.
Place a terminator in
the 'data out' connector
of last fixture on the link
Roadster Orbital Head System User Manual