CyberData 11180 Operation Manual page 54

On the Audio Configuration page, enter values for the parameters indicated in
Note
Web Page Item
Audio Files
0-9
Dot
Audiotest
Pagetone
Talk
Listen
Your IP Address is
Rebooting
Restoring default
Ringback Tone
Ring Tone
Night Ring
Operations Guide
Each entry on the Audio Configuration page replaces one of the stock audio files on the
board. When the input box displays the word default, the Talkback Speaker is using the
stock audio file. If that file is replaced with a user file, it will display the uploaded filename.
Table 2-12. Audio Configuration Parameters
Description
The name of the audio configuration option is the same as the spoken audio that
plays on the board (24 character limit).
'0' corresponds to the spoken word "zero."
'1' corresponds to the spoken word "one."
'2' corresponds to the spoken word "two."
'3' corresponds to the spoken word "three."
'4' corresponds to the spoken word "four."
'5' corresponds to the spoken word "five."
'6' corresponds to the spoken word "six."
'7' corresponds to the spoken word "seven."
'8' corresponds to the spoken word "eight."
'9' corresponds to the spoken word "nine."
Corresponds to the spoken word "dot." (24 character limit)
Corresponds to the message "This is the CyberData IP speaker test message..."
(24 character limit)
Corresponds to a simple tone used for beep on initialization and beep on page
(24 character limit).
While in Monitor
are switching from the "listening mode" to the "talking mode."
While in Monitor
they are switching from the "talking mode" to the "listening mode."
Corresponds to the message "Your IP address is..." (24 character limit).
Corresponds to the spoken word "Rebooting" (24 character limit).
Corresponds to the message "Restoring default" (24 character limit).
This is the ringback tone that plays when calling a remote extension
(24 character limit).
This is the tone that plays when set to ring when receiving a call
(24 character limit).
Specifies the ringtone for nightring. By default this parameter uses the same audio
file that is selected for the Ring Tone parameter.
The Browse button will allow you to navigate to and select an audio file.
The Play button will play that audio file.
930468A
Mode, the person at the phone will hear the word "talk" when they
Mode, the person at the phone will hear the word "listen" when
Installing the VoIP V2 Speaker
Configure the Audio Parameters
Table 2-12.
CyberData Corporation
46