CyberData 11180 Operation Manual page 41

2. On the Network Configuration page, enter values for the parameters indicated in
Web Page Item
Stored Network Settings
IP Addressing
IP Address
Subnet Mask
Default Gateway
DNS Server 1
DNS Server 2
DHCP Timeout
DHCP Timeout in seconds
Current Network Settings
IP Address
Subnet Mask
Default Gateway
DNS Server 1
DNS Server 2
3. After changing the parameters, click Save Settings. This updates the changed parameters and
reboots the Talkback Speaker if appropriate.
4. Connect the Talkback Speaker to the target network.
5. From a system on the same network as the Talkback Speaker, open a browser with the new IP
address of the Talkback Speaker.
Operations Guide
Table 2-7. Network Configuration Parameters
Description
Shows the settings stored in non-volatile memory.
Select either DHCP IP Addressing or Static IP Addressing by
marking the appropriate radio button. If you select Static, configure
the remaining parameters indicated in
go to Step 3.
Enter the Static IP address.
Enter the Subnet Mask address.
Enter the Default Gateway address.
Enter the DNS Server 1 address.
Enter the DNS Server 2 address.
Enter the desired timeout duration (in seconds) that the device will
wait for a response from the DHCP server before defaulting back to
the stored static IP address.
Note: A value of -1 will cause the device to retry indefinitely and a
value of 0 will cause the device to reset to a default of 60 seconds.
Shows the current network settings.
Shows the current Static IP address.
Shows the current Subnet Mask address.
Shows the current Default Gateway address.
Shows the current DNS Server 1 address.
Shows the current DNS Server 2 address.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.
930468A
Installing the VoIP V2 Speaker
Configure the Network Parameters
Table
Table 2-7 . If you select DHCP,
CyberData Corporation
33
2-7.