Billion BiPAC 7700N User Manual page 96

Parameters
Traffic Class Name: Assign a name for this class to uniquely identify the others among multiple
classes.
Rule Order: Select the priority for this class rule.
Rule Status: Select Enable to activate this class rule.
Specify Classification Criteria
The following parameters are to be classification rule. Enter or select appropriate parameters on the
following fields. A blank criterion indicates it is not used for classification.
Class Interface: select the interface you want to be the one aspect of the classification criteria.
Here "LAN" and "WAN" can be viewed as IP QoS, the others can be viewed as ported-based QoS,
which means that control the QoS of certain port such. For example, if you select eth0 port, then
criteria applies to this port, that is ported-based QoS.
Entry Type: select the application type.
Source/destination MAC Address: enter the source and destination MAC address as the QoS
Classification Criteria. The format should be xx:xx:xx:xx:xx:xx.
Source/destination MAC Mask: MAC mask is similar to IP mask, and the format also should be
xx:xx:xx:xx:xx:xx. It is used to hide some information of the MAC address. '1', means needed and '0'
means ignored. For example, MAC address e0:3b:4a:c2:ca:e2 and MAC mask ff:ff:ff:00:00:00, that
is whatever MAC address while matches e0:3b:4a:XX:XX:XX, will be accepted.
Specify Classification Results
Enter or select appropriate parameters you want for the packets matched the above classification
criteria in the following fields. You have to choose a classification queue. A blank mark or tag value
means no change.
Assign Classification Queue: assign classification queue from the drop-down box. If you want to
select the queue, you should make sure the specific queue is enabled in Queue Config section.
Mark Differentiated Service Code Point (DSCP): select the DSCP you want to be the new DSCP
for the packets which matched the above classification criteria.
Mark 802.1p priority: it is a LAN Layer 2 QoS/CoS Protocol for Traffic Prioritization. It is
interoperable with IEEE 802.1Q. 802.1p has 8 kinds of priority.
Tag VLAN ID: enter the tag VLAN ID, 0-4094, used to determine the VLAN the frame belongs to.
Note: 802.1p/vlan tag feature be supported only when in bridge mode, DSL WAN interface.
Click Apply/Save to confirm the settings and you will be returned to the QoS Classification page.
Enable: To disable the item, please uncheck Enable check box then click Enable button.
Remove: To delete the QoS class from the table, check Remove checkbox then click Remove
button to delete the selected item.
93