Section 7: Appliance Set-Up; Reverse Top Or Rear Flue Adapter; Leveling System; Top Vent - Quadra-Fire Castile Insert Pellet 810-02901 (MBK) Owner's Manual

Castile Pellet Insert
7
Appliance Set-Up
A. Reversible Top or Rear Flue Adapter
Top Vent Installation
1. Release ammo can latches on each side. Figure 16.1.
2. Place the reversible adapter in the correct position for your
installation.
3. Make sure BOTH latches are in position before securing
them.
Rear Vent Installation
o
1. Remove the 90 adapter and installation screws from the
packaging.
o
2. Attach the 90 adapter onto the vent adapter, using the 3
screws provided. You will need to pre-drill the holes for screw
placement. Be sure to adjust the 90
position for venting before drilling.
3. Silicone the pipe joints according to the Note below.
NOTE: All pipe must be sealed using welded
seam pipe whenever possible. Seal pipe joints
with high temperature silicone, minimum rate of
0 0
500 F (260 C).
Ammo Can Latches
Figure 16.1 - Top Vent
Figure 16.2 - Rear Vent
Page 16
o
adapter to the desired
screw
Figure 16.3 - Rear Vent
250-7251F
B. Leveling System
The back legs are adjustable to allow for customized fit
into zero clearance boxes.
1. Loosen 2 top screws and remove 2 bottom screws.
2. Adjust leg to desired height. Leg can slide up (shorter)
or down (longer) to level the insert.
3. Tighten 2 top screws.
4. Drill 2 holes for the bottom 2 screws and re-install
screws. Figure 16.5.
Loosen top 2 screws and remove
bottom 2. Adjust leg to desired height.
Figure 16.4
Drill 2 holes and
re-install bottom 2
Figure 16.5
screws
September 1, 2008
R