Panel Set & Cast Trim Set; Panel & Trim Set, Econo - Quadra-Fire Castile Insert Pellet 810-02901 (MBK) Owner's Manual

R
E. Panel Set And Cast Trim Set
Included in Panel Kit: (2) side panels, left and right; (1)
panel top; (1) fastener package.
Included in Cast Trim Kit: (2) cast trim legs, left and right; (1)
cast trim header; (2) cast trim footers, left and right; (1) fastener
package.
Tools Needed: Powered Phillips head screw driver
1. Remove contents from box being careful not to scratch or
damage the cast trim pieces.
2. Lay the panel set face down on protective covering to prevent
scratching the painted surface.
3. Secure the panels legs to top panel with the screws provided.
4. Now bend the tabs down toward the backside of the panel set,
5 on top and 2 on each leg. Leave the panel set face down.
5. Place the corresponding cast trim pieces ( 2 cast trim legs and
1 cast trim header) underneath the panel set, also face down.
6. Place washer provided over tab and secure the trim and panel
together with screw. Continue for all tabs.
7. Secure cast footers with screws.
8. Remove both left and right cast sides from insert, See Figures
28A, 28B and 28C on page 28.
9. Slide panel and trim over the top of the insert into place matching
the mounting tabs on the panel with the slots on the insert.
CAUTION
• Do NOT pick up assembled unit by corners.
• It is too heavy and may damage the panels.
• Pick up from center.
2. Bend tabs down
1. Screw panels
together
3. Install Cast Trim Header
Figure 19.1
September 1, 2008
1. Screw panels
together
2. Bend tabs
down
Mounting tabs on each panel leg
to match up with slots on insert.
Figure 19.2 - Completed View
of Panel Set & Cast Trim Set
250-7251F
F. Panel & Trim Set, Econo
Included in Panel & Trim Kit:
screws; (1) trim set, 3 piece; (2) side panels; (1) top panel;
(4) screws;
Tools Needed: Powered Phillips head screw driver
1. Secure the top panel to the panel sides with the
screws provided. Figure 19.3.
2. Assemble the gold trim with the (2) corner brackets
provided. Figure 19.4.
3. Slide the assembled trim over the assembled panel
set.
Slide panel and trim over the top of the insert into
4.
place matching the mounting tabs on the panel with
the slots on the insert.
Back of Top Panel
Figure 19.3
View of "L" Bracket
installed
Figure 19.4
Castile Pellet Insert
(2) corner brackets and set
Screws
Back of Side Panel
Page 19