Positioning The Logs - Heat & Glo CERONA-36 Owner's Manual

G. Positioning the Logs
Model: Cerona-36
If the gas logs have been factory installed they should not need to be positioned. If the logs have been packaged separately,
refer to the following instructions.
Figure 2
STEP 1.
LOG #1 (SRV2106-701):
the right side of the pilot bracket (B). Move the right end of log #1 forward until it hits the stick on the burner (A). The closer
the log is to the burner the more glow you will get. Don't place the log too close to the burner or sooting may occur.
FORMED FORMED
GROOVE GROOVE
Figure 4
STEP 2.
LOG #2 (SRV2106-703):
top branch of log #1 (A). Rest the formed groove of the lower
part of the log on the grate. It may be necessary to tilt Log
#1 forward to properly engage with Log #2.
6 6
1 1
Figure 1
CAUTION: Carefully remove the logs from the packaging.
Logs are fragile!
1 1
Place the notch on the left underside of log #1, over the log tab that is located on
A A
2 2
Fit log #2 on the
Heat & Glo • Cerona-36, Cerona-42 • 2106-900 Rev. W • 9/15
Log Assembly: LOGS-Cerona36
5 5
3 3
4 4
2 2
Figure 3
Figure 5
STEP 3.
LOG #3 (SRV2106-705):
of the log in the grate tine and rest the log on the formed
portion of log #2.
1 1
B B
A A
3 3
Place the "Y" portion
2106-935B
51