Table of Contents
Advertisement
Result Codes
When the ProxyServer receives an AT command from the computer or terminal, it attempts to
execute the command, then sends a status message to the computer or terminal that reports the
result of the command. The ProxyServer provides you with several of these response messages, or
result codes, which can be displayed on your monitor or intercepted and used by your
communications software. Using the V command, you can select whether the result codes are terse
(numbers) or verbose (words).
The ProxyServer's result codes are listed below. Note that the speed of an ISDN channel is always
either 56 Kbps or 64 Kbps. CONNECT messages indicate the speed of the connection between the
ProxyServer and your computer or terminal.
Terse Verbose
0
OK
1
CONNECT
2
RING
3
NO CARRIER
4
ERROR
5
CONNECT 1200
6
NO DIALTONE
7
BUSY
8
CONNECT 300
10
CONNECT 2400
11
CONNECT 4800
12
CONNECT 9600
14
CONNECT 19200
28
CONNECT 38400
32
CONNECT 48000
17
CONNECT 56000
18
CONNECT 57600
19
CONNECT 64000
20
CONNECT VOICE
57
CARRIER 56000
59
CARRIER 64000
78
SOFTBONDING
PROTOCOL
79
PPPC PROTOCOL
96
CHANNEL B1
97
CHANNEL B2
MTPSR1-202ST
Definition
ProxyServer executed the command without error.
ProxyServer has established an ISDN connection.
ProxyServer has detected a ring caused by an incoming call.
ProxyServer did not detect a carrier within the time allotted by register S7.
There was an error in the AT command.
ProxyServer has connected at 1200 bps.
ProxyServer has a poor connection to the ISDN network.
ProxyServer has detected a busy signal.
ProxyServer has connected at 300 bps.
ProxyServer has connected at 2400 bps.
ProxyServer has connected at 4800 bps.
ProxyServer has connected at 9600 bps.
ProxyServer has connected at 19200 bps.
ProxyServer has connected at 38400 bps.
ProxyServer has connected at 48000 bps.
ProxyServer has connected at 56000 bps.
ProxyServer has connected at 57600 bps.
ProxyServer has connected at 64000 bps.
ProxyServer has made a voice connection.
ProxyServer has detected a 56000 bps carrier.
ProxyServer has detected a 64000 bps carrier.
ProxyServer is using the SoftBonding protocol.
ProxyServer is using the Point-to-Point protocol.
Channel B1 is in use.
Channel B2 is in use.
Appendixes
119
Advertisement
Table of Contents
