Configuring in Windows 98/95
Perform the following steps to set up your Windows 98/95 PC:
Note: All of the hardware and screens used in this section are intended as examples only. Please
select options appropriate to your system.
1. Click Start | Settings | Control Panel and then double click the Network icon.
The Network dialog box Configuration tab is displayed, which shows all the components (i.e.,
clients, adapters, protocols, and any services) installed on your PC.
2. If TCP/IP is listed, proceed to step 3; otherwise, refer to Installing TCP/IP (Win98/95), at the end
of this section.
MTPSR1-202ST
Chapter 5 - Client Setup
51