Table of Contents
Advertisement
ProxyServer User Guide
Adding RAM
A second SIMM connector is provided for adding RAM to the ProxyServer. Do the following.
Note: Memory should only be added when required by Multi-Tech Systems.
1. Ensure that the external power supply is disconnected from the ProxyServer.
2. Turn the ProxyServer upside down and remove the cabinet mounting screw located at the center
back of the cabinet (Refer to Figure 2-3).
3. Turn the ProxyServer right side up, then slide the base out the rear of the cabinet.
4. Position the base so the front panel LEDs are facing toward you (Refer to Figure 2-4).
5. Slant the new SIMM at a 45
SIMM with the center tab on the SIMM connector.
6. Gently press down on the ends of the SIMM until the two short vertical white pins enter the holes
at the ends of the SIMM and the two metal side clips snap in place over the SIMM, locking it
down (Refer to Figure 2-4).
7. Align the base with the mating guides on the inside of the cabinet, then slide the base all the way
into the cabinet until it stops.
8. Turn the ProxyServer upside down and replace the cabinet mounting screw that was removed in
step 2.
9. Turn the ProxyServer right side up and connect the cables.
14
Cabinet Mounting Screw
(center, back)
Figure 2-3. Cabinet Mounting Screws
0
angle to the back of the base and align the centering notch of the
Figure 2-4. Installing a SIMM
MTPSR1-202ST
Advertisement
Table of Contents
