Table of Contents
Advertisement
Command:
@CONFIG
Function:
Start ConfigMenu
Values:
none
Default:
none
Description:
The @CONFIG command starts the ProxyServer's internal configuration utility,
which you can then use to customize the ProxyServer's configuration for your
particular application. You must enter the command while in your communication
program's terminal mode.
S-Registers
S-Registers are sections of memory in which values are stored that affect how the ProxyServer
operates. S-Registers are so-called because each has a name that begins with the letter S. Use the
S command to assign a value to or to read the current value of an S-register. To assign a value to an
S-register, use the command Sr=n, in which r is the register number, and n is the value you want to
assign to the register, e.g., S7=45. To read an S-register value, use the command Sr?, in which r is
the register number, e.g., ATS7?.
S-Register
Function
S0
Rings Until Answer
S1
Ring Count
S2
Escape Character
S3
Carriage Return Character
S4
Line Feed Character
S5
Backspace Character
S7
Wait for Connection (Abort Timer)
S10
DCD Drop Time
S25
DTR Drop Time
S26
Delay DTR Monitoring
S32
Escape Sequence Timeout
S50
Caller Line ID ("CLI")
S52
Auto-Protocol Detection
S53
Maximum Frame Size (X.75)
S54
Force 56 Kbps B-Channel Data Rate
S55
Set Information Transfer Capability for POTS port calls
S-Register:
S0
Function:
Number of Rings Until Answer
Unit:
1 ring
Range:
0–255
Default:
1
Description:
S0 sets the number of rings the ProxyServer waits for before it answers and begins
its connect sequence. S0=0 turns off the ability to automatically answer a call. S0=1
causes the ProxyServer to automatically answer after 1 ring. Note that if the S0
value is set too high, the calling device may time out before the ProxyServer answers
the call. For autoanswer, S0 must have a non-zero value, DTR must be high (&D
command), and the ProxyServer must be offline.
S-Register:
S1
Function:
Ring Count
Unit:
1 ring
Range:
0–255
Default:
0
Description:
S1 counts the number of rings that have occurred, up to a maximum of 255. It is a
read-only register and is seldom, if ever, used in typical operation. If you set S1 to a
value other than its default value of zero, or if the value is increasing with rings, this
new value remains stored in S1 for eight seconds after the last ring is counted, after
which time the value reverts to zero.
MTPSR1-202ST
Appendixes
115
Advertisement
Table of Contents
