Connecting The Receiver To The Tv(S) In Another Room(S) - Dish Network Receiver User Manual

Connecting the Receiver to the TV(s) in Another
Room(s)
This section describes how to connect the receiver
the cable-ready remote TV located in another room away from the receiver. This
installation uses your in-home cable system. If your house does not have built-in
cabling, it will be necessary to run cables from the receiver to each remote TV.
Due to the difficulty of this installation, you should consider having this
professionally installed. Call DISH Network at 1-800-333-DISH (3474).
UHF Remote Control
: When connecting to the home distribution (
Note
you must meet the FCC requirements in the Appendix. To meet these
requirements, an in-line coaxial attenuator has been included with your receiver
and may need to be installed using the following guidance:
• If connecting to your in-home cabling system to distribute the signal to a
TV(s) in other rooms, in most cases you will not have to install the
attenuator on the
• If connecting directly to a TV tuner port, you must install the attenuator in
the cable between the
Receiver Back Panel

Connecting the Receiver to the TV(s) in Another Room(s)

Remote TV
2
port for typical in-home cabling systems.
CH 21–69
port and the TV tuner.
CH 21–69 O
UT
Attenuator
connection to
CH 21–69 O
UT
Coaxial
Cable
Wall
Outlets
) coaxial port,
CH 21–69 O
UT
Page 31