S-Video Out; Tv2 Connections - Dish Network Receiver User Manual

S-Video Out

The connection provides the highest quality video
S-V
IDEO
available to your nearby TV (if your TV has this connection).
Use an S-Video cable to make the connection. If you use this
back panel output for video between your receiver and nearby
TV, you must still connect the audio using the
A L /R O
UDIO EFT IGHT UTPUTS
TV Antenna/Cable In
The
TV A /C
NTENNA ABLE
receiver to connect the tuner of the nearby TV to an off-air
antenna or cable TV system when the satellite receiver is turned
off or when using the TV/VIDEO button on Remote Control 1.
Use a coaxial cable to make this connection to an off-air antenna
or cable TV system. The
color coded black. Your nearby TV must be connected to the
output to use this feature.
C 3-4
HANNEL

TV2 Connections

The following connections provide menus and programming to the remote TVs.
These connections are active when the satellite receiver is in
with
Single Mode Shared View
CH 21–69 Out
The connection provides good quality video and
CH 21–69 O
UT
mono (non-stereo) audio for the remote TV(s).
Use a coaxial cable to make this connection to your home cable
system. Remote TVs connected to the home cable system can
receive programming from this receiver output. The
connection is color coded yellow.
O
UT
: When connecting to the home distribution (
Note
coaxial port, you must meet requirements covered under FCC
Compliance in the Appendix. To meet these requirements, an in-line
coaxial attenuator has been included with your receiver and may
need to be installed using the following guidance:
• If connecting directly to a TV tuner port, you must install the
attenuator in the cable between the
TV tuner.
• If connecting to your in-home cabling system to distribute the
signal to a TV(s) in other rooms, in most cases you will not have
to install the attenuator for typical in-home cabling systems.
P
and Phono (RCA) cables.
is used if you want the satellite
I
N
TV A /C I
NTENNA ABLE N
enabled.
(RCA)
HONO
connection is
Dual Mode
CH 21–69
CH 21-69 O
port and the
CH 21-69 O
UT
Receiver Back Panel
Tip: If you connect
a cable to the TV/
Antenna In port,
attach the black
cable sticker to the
cable near where it
attaches to the
receiver. The
stickers are
located inside the
front cover of this
guide.
or in
)
UT
Page 25