Check The Device Codes - Dish Network Receiver User Manual

6. Press the UP or DOWN
ARROW button repeatedly
until the device turns off.
7. Press the POUND (#) button.
8. Turn the device back on and
try some other buttons to
make sure they work.
9. Repeat this procedure until
you've tried all the codes.

Check the Device Codes

You can find out what device code you've set for each remote control mode.
1. Press and hold the mode
button until all the other mode
buttons light up, and then let
go of the button.
The mode button flashes.
2. Press the POUND (#) button
twice.
Watch the mode light to
determine your code. The
mode button flashes the
number for each digit of the
device code, with a pause
between the groups of flashes.
A quick flash is for zero.
3. For AUX mode only. The first
group of flashes tells you what
the AUX mode controls. A
quick flash (zero) before the
three-digit code is for a TV;
one regular flash is for a VCR
or DVD/BD player; and two
flashes is for a tuner or
amplifier.
Control Other Devices with the Remote Controls
As you press the UP or DOWN
ARROW button, the remote is
trying each code in the memory to
see if it can turn off your device.
When the device turns off, you have
found a code that might work.
Note: The mode button for the
device will flash rapidly eight times
when you've scanned all the codes
for that device.
This stores the code you found.
Press the blank POWER button to
turn the device back on. Try some
other buttons to make sure they
work. Sometimes, the blank
POWER button works when other
buttons don't.
You may need to repeat the scan to
find the best code for your device.
For example, hold the TV mode
button for a TV until all of the other
mode buttons light. When you let
go, the TV mode light will flash.
For example, if the code is 570, the
mode button flashes five times,
pauses, flashes seven times, pauses,
and flashes once quickly.
For example, if the TV code is 570,
the AUX mode button flashes once
quickly (indicating 0 for TV),
pauses, flashes five times, pauses,
flashes seven times, pauses, and
flashes once quickly.
Tip: In Dual Mode,
Remote Control 1
is used to control
TV1 menus on the
nearby TV. Remote
Control 2 is used to
control TV2 menus
on the remote
TV(s).
Page 107