Digital Audio Out - Dish Network DISH 625 Description And Installation Manual

Dish network tv receiver description and installation
Table of Contents

Advertisement

Digital Audio Out

The
D
A
O
IGITAL
UDIO
UTPUT
sound decoding systems. Connect the
with a Digital Audio Optical cable (available at consumer
electronics stores).
TV Antenna/Cable In
The
TV A
/C
NTENNA
ABLE
receiver to connect the tuner of the nearby TV to an off-air
antenna or cable TV system when the satellite receiver is turned
off or when using the TV/VIDEO button on Remote Control 1.
Use a coaxial cable to make this connection to an off-air antenna
or cable TV system. The
color coded black. Your nearby TV must be connected to the
output to use this feature.
C
3-4
HANNEL
TV2 Connections
The following connections provide menus and programming to the remote TVs.
These connections are active when the satellite receiver is in
with
Single Mode
Shared View
CH 21–69 Out
The
connection provides good quality video and
CH 21–69 O
UT
stereo audio for the remote TV(s). Use a coaxial cable to make
this connection to your home cable system. Remote TVs
connected to the home cable system can receive programming
from this receiver output. The
color coded yellow.
: When connecting to the home distribution (
Note
coaxial port, you must meet requirements covered under FCC
Compliance in the Appendix. To meet these requirements, an in-line
coaxial attenuator has been included with your receiver and may
need to be installed using the following guidance:
• If connecting directly to a TV tuner port, you must install the
attenuator in the cable between the
TV tuner.
• If connecting to your in-home cabling system to distribute the
signal to a TV(s) in other rooms, in most cases you will not have
to install the attenuator for typical in-home cabling systems.
is for use with high-quality digital
D
A
IGITAL
UDIO
is used if you want the satellite
I
N
TV A
/C
I
NTENNA
ABLE
N
enabled.
connection is
CH 21–69 O
UT
O
UTPUT
connection is
Dual Mode
CH 21-69 O
port and the
CH 21-69 O
UT
Receiver Back Panel
Tip: If you connect
a cable to the TV/
Antenna In port,
attach the black
cable sticker to the
cable near where it
attaches to the
receiver. The
stickers are
located inside the
front cover of this
guide.
or in
)
UT
Page 25

Advertisement

Table of Contents
loading

Table of Contents