Point Dish And Check Switch - Dish Network ViP222 User Manual

Chapter 11
Using Troubleshooting Tools

Point Dish and Check Switch

The Point Dish and Check Switch screens are helpful to DISH Customer Service Representatives.
You may be asked to display these screens when you call DISH. Even though there are items that
can be changed, only change them when specifically directed by a DISH Customer Service
Representative.
Warning: Running the Check Switch test while the receiver has low or no signal will result
in incorrect receiver settings and cause you to lose channels. Do not run a Check Switch
test unless directed to by a DISH Customer Service Representative or other instructions
approved by DISH.
1
Press the MENU button.
2
Select System Setup.
3
Select Installation.
4
Select Point Dish. This screen shows you information to help maximize your satellite signal. The
bar at the bottom of the screen tells you the signal strength. Green is a good signal, while red
indicates the signal is not acceptable or is from the wrong satellite.
5
Select Check Switch to display the Installation Summary screen. The Installation Summary
screen tells you if you are receiving signals from the satellites and which multi-dish switches you
have installed, if any.
6
Select Test only if directed to do so by a DISH Customer Service Representative.
7
When you are finished with the menus, select Done.
104