State-Based Softkey - Aastra 9480i User Manual

State-Based Softkey

On the 9480i softkeys, you can configure a specific state to display when a softkey is being used.
The following table describes the states available to configure for the softkeys.
State
idle
connected
incoming
outgoing
busy
The following table identifies the applicable default states for each softkey type on the IP phone.
Softkey Type
None
Line
Speed Dial
DND
BLF
BLF List
Auto Call Distribution (ACD)
Directed Call Pickup (DCP)
Group Call Pickup (GCP)
XML
Flash
Sprecode
Park
Pickup
Last Call Return
64
Softkeys
(state-based)
Description
The phone is not being used.
The current line is in an active call (or the call is on hold).
The phone is ringing.
The user is dialing a number, or the far-end is ringing.
The current line is busy because the line is in use or the line is set as "Do Not Disturb".
Default States
All states disabled.
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
idle
idle, connected, incoming, outgoing, busy
idle, connected, incoming, outgoing, busy
All states disabled.
connected
connected
idle, outgoing
idle, connected, incoming, outgoing, busy
Model 9480i IP Phone User Guide