S
S
UPER
ERVER 6027AX-TRF/6027AX-72RF User's Manual
5-5
Installing Memory
Caution! Exercise extreme care when installing or removing DIMM modules to
prevent any possible damage.
Memory Support
The X9DAX-7F/iF supports up to 512 GB of DDR3 Registered(RDIMM)/Load Re-
duced (LRDIMM) ECC or up to 128 GB of Unbuffered (UDIMM) ECC/Non-ECC
1600/1333/1066/800 MHz 4-channel memory modules in 16 DIMM slots. All chan-
nels will run at the fastest common frequency.
DIMM Installation
Installing Memory Modules
1. Insert the desired number of DIMMs into the memory slots starting with P1-
DIMMA1. See the Memory Installation Tables below.
2. Insert each DIMM module vertically into its slot. Pay attention to the notch
along the bottom of the module to avoid installing incorrectly (see Figure 5-3).
3. Use your thumbs to gently press down on both ends of the DIMM module
until it snaps into place in the slot. Repeat for all modules.
4. Press the release tabs to the locked positions to secure the DIMM module
into the slot.
To Install: Insert module
vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Figure 5-4. DIMM Installation
Notch
Release Tab
Top View of DDR3 Slot
5-8
Front View
Notch should align with the
receptive key point on the
slot.
Notch
Release Tab