Cisco IP Communicator Administration Manual page 124

Viewing Operational Information Locally on the Cisco IP Communicator Interface
Table 7-3 Status messages displayed on Cisco IP Communicator
Message Description
CFG file not The name-based and
found default configuration
file was not found on the
TFTP Server.
CFG TFTP Size The PC's hard disk is
Error full.
Checksum Error Downloaded software
file is corrupted.
DHCP timeout DHCP server did not
respond.
Cisco IP Communicator Administration Guide for Cisco CallManager
7-6
Chapter 7
Possible Explanation and Action
The configuration file for a application is created when
the application is added to the Cisco CallManager
database. If the application has not been added to the
Cisco CallManager database, the TFTP server generates
a
CFG File Not Found
If the device is not registered with
•
Cisco CallManager.
You must manually add the device to
Cisco CallManager if you are not allowing devices
to auto-register. See the
Cisco CallManager Database" section on page 2-10
for details.
If you are using DHCP, verify that the DHCP server
•
is pointing to the correct TFTP server.
If you are using static IP addresses, check
•
configuration of the TFTP server.
Delete some files
Obtain a new copy of the application software and place
it in the TFTPPath directory. You should only copy files
into this directory when the TFTP server software is shut
down, otherwise the files may be corrupted.
Network is busy—The errors should resolve
•
themselves when the network load reduces.
No network connectivity between the DHCP server
•
and the application—Verify the network
connections.
DHCP server is down—Check configuration of
•
DHCP server.
Errors persist—Consider assigning a static IP
•
address.
Viewing Operational Information
response.
"Adding Devices to the
OL-4698-01