imagistics cm4530 Printing Manual page 168

•
NOTE:
168
3.
Select the PPD file (Imagistics_cm4530Series) for the equip-
ment and click [Select].
4.
Select each option according to the configuration of this
equipment and click [OK].
— Finisher
Not Installed — Select this if a finisher is not installed.
Single Position Stapler — Select this when the Single-staple Finisher (only for
cm3530) is installed.
Multi-Position Stapler — Select this when the Multi-staple Finisher or Sad-
dle-stitch Finisher is installed.
Multi-Position Stapler and Hole Punch — Select this when the Multi-staple
Finisher or Saddle-stitch Finisher and Hole Punch unit are installed.
When you select "Multi-Position Stapler" or "Multi-Position Stapler and Hole Punch",
the saddle-stitching function will be selectable for printing. However, saddle-stitch-
ing is available only when the Saddle-stitch Finisher is installed.
— Pedestal
Not Installed — Select this when no pedestal is installed.
Pedestal 1 — Select this when the Paper Feed Pedestal is installed.
Pedestal 2 — Select this when the Paper Feed Pedestal and Drawer Module are
installed.
LCF — Select this when the Large Capacity Feeder is installed.
5.
Close the Chooser Dialog box.
• The Printer icon is created on the desktop.
Printing Guide — Installing Client Software for Macintosh