imagistics cm4530 Printing Manual page 166

10.
NOTE:
12.
166
Click the [Printing] menu and select [Change Setup...].
• The LaserWriter setup dialog box appears.
11.
Select each option item in the "Change" drop down menu
and select installed option in the "To" drop down menu
according to the configuration of this equipment.
— FInisher
Not Installed — Select this when no finisher is installed.
Single Position Stapler — Select this when the Single-staple Finisher (only for
cm3530) is installed.
Multi-Position Stapler — Select this when the Multi-staple Finisher or Sad-
dle-stitch Finisher is installed.
Multi-Position Stapler and Hole Punch — Select this when the Multi-staple
Finisher or Saddle-stitch Finisher and Hole Punch unit are installed.
• When you select "Multi-Position Stapler" or "Multi-Position Stapler and
Hole Punch", the saddle-stitching function will be selectable for print-
ing. However, saddle-stitching is available only when the Sad-
dle-stitch Finisher is installed.
— Pedestal
Not Installed — Select this when no pedestal is installed.
Pedestal 1 — Select this when the Paper Feed Pedestal is installed.
Pedestal 2 — Select this when the Paper Feed Pedestal and Drawer Module are
installed.
LCF — Select this when the Large Capacity Feeder is installed.
Click [OK].
Printing Guide — Installing Client Software for Macintosh