System Features; Remote Administration - NetComm NTC-6000 SERIES User Manual

Wireless M2M

System Features

10.1 Remote administration

This facility is available by clicking on the "System" menu followed by "Administration".
Once Remote administration is enabled, you are able to access the router's web-based configuration pages from a remote location to
make configuration changes and to enable or disable features.
To get remote access, you have to connect to the WAN IP address of the router on the port assigned in the configuration page (e.g. 8080)
after a connection to the cellular network via a data connection has been established.
To configure Remote Administration follow the steps below:
Click "Enable" to activate Remote Administration
Change the Remote Administration Port number if required; the factory default is 8080.
You may change the remote access password for enhanced security.
Click "Save"
Note: The password will only be changed if you enter two matching passwords. It is not necessary to change the password if you are only changing the incoming port number.
The WAN IP address below is an example only, yours will be different.
Below illustrates the steps required to access the router's configuration pages remotely from a remote computer:
1. Open a new browser window (e.g. Internet Explorer, Firefox, Safari ...).
2. In the address bar, enter the router's WAN IP address and assigned port number, e.g. "10.10.10.10: 8080".
Note: You can find the router's WAN IP address by clicking on the "Status" menu. The Local field in the WWAN section shows the router's WAN IP address.
3. Click "Login" and type "admin" or "root" in the Username and "admin" in the Password fields (without quotes). Then click on
"Submit".
Note: To perform functions like Firmware upgrade, device configuration backup and to restore and reset the router to factory defaults, you need to login as the root user.
NTC-6000 Series User Guide
48
http://10�10�10�10:8080
Username
Password
http://10�10�10�10:8090
Username
Password
admin
admin
root
admin
YML6000
www.netcomm.com.au