Code Calling - Toshiba PERCEPTION 4000 User Manual

PERCEPTION 4000
To Perform a Camp-on Transfer:
1. Wait for success tone and then
hang up your telephone to
transfer the held call.
To Place a Code Call:
1. Press the hookswitch to place
any current caller on "soft
hold."
. . . or . . .
Go off-hook.
2. Enter the Code Calling
access code, plus the desired
code call paging zone number.
3. Enter the desired code call
identity code.
After establishing a two-way connection, placing the call on "soft hold,"
and dialing a busy third party:
The formerly-held call will now be camped-on to the busy line.
When the line becomes idle, the held party will hear ringback tone. Once
the party answers, the call will proceed as a normal call.
NOTES:
1. The Camp-on Transfer feature is not available if the held party has
another party on hold, or if the held party is involved in a conference.
2. If the held call is camped on to the busy line longer than allowed by
the predetermined timeout period, the held call will recall to your
station.

CODE CALLING

You can page an individual via a Code Calling chime or bell if your
system is equipped for this operation. You can page the party to pick up
another held call or to pick up your call.
When placing a caller on "soft hold," listen for recall dial tone. The call will
be held until it is retrieved by the paged party.
Listen for recall dial tone.
If the Code Calling circuit is busy, you can connect to the held call by
pressing the hookswitch.
If the code is accepted, you will hear success tone.
FEATURE OPERATION
2-15