Call Hold - Toshiba PERCEPTION 4000 User Manual

PERCEPTION 4000
To Place a Call on Hold:
1. Establish a two-way
connection.
2. Inform the connected party
that he/she is being placed on
hold.
3. Press the hookswitch.
4. Enter the Call Hold access
code.
5. Leave the telephone handset
off-hook.
To Retrieve a Held Call:
1. Press the hookswitch.
2. Wait to be connected to the
held call.
2-6
Answer will not route calls to a Do Not Disturb station's Call Forward
destination.
9. If you call a station that is forwarded to another station, and that
destination station is busy (and does not have Call Forward
registered), your call will ring the initially-called station (if the station
is idle).

CALL HOLD

You can place a current call on hold by using your station's hookswitch.
The held call can be retrieved only from your station. (To hold calls for
retrieval from another telephone, refer to the operational instructions for
the Call Park—Remote feature.)
Listen for recall dial tone.
Listen for success tone, followed by quiet tone.
The call will remain on hold until it is retrieved or until the connected
party hangs up.
If you hang up your telephone, the call will recall your station
immediately. If the recall is unanswered (and the call is a trunk call), then
after a predetermined time period, the call will recall to the attendant or to
an alternative answering position.
NOTE:
If you attempt to retrieve the held call after the held party has already
hung up, you will hear quiet tone.
FEATURE OPERATION