Table of Contents
Advertisement
1.25
SWEEPER DRIVE SWITCH
The sweeper/collector drive switch engages and disengages drive to the
sweeper brush.
Engage Drive - Pull the sweeper drive switch out.
Disengage Drive - Push the sweeper drive switch in.
SWEEPER WORKING HEIGHT SETTING
The sweeper working height lever is used to raise and lower the sweeper brush
to the desired working height.
Move the lever outwards to disengage it from the working height notches, then
push forwards to lower or pull backwards to raise the working height. Release
the lever into the required position and ensure that it locks securely into the
appropriate notch.
There are six working height positions. These are indicated by the numbered
notches, 1-6.
IMPORTANT: Always select the working height to suit operating conditions.
It is recommended that for optimum collection performance the working
height of the sweeper is selected to correspond with the height of cut of the
cutterdeck as indicated by the numbers 1-6.
EMPTYING THE SWEEPER COLLECTOR
The viewing hatch in the front of the sweeper collector housing can be used
to check if the collector is full. (Refer fig.1)
WARNING: PREVENT ACCIDENTS - Ensure that the tractor is sta-
tionary and the drive to the sweeper is disengaged before emptying the
grass collector.
The grass collector can be emptied by extending the tipping lever to its full
extent and pulling it forwards. The grass hopper will rotate around its piv-
ots, and allow the grass clippings to empty out. (Refer fig.2)
The floor of the grass collector will lift as the hopper rotates and this assists
with emptying. Two cables connecting the floor to the hopper provide this
function.
When empty, close the grass collector by allowing the hopper to gently drop
down. The collector floor will naturally resume its level position.
Allow the tipping lever to drop back into its fully retracted position.
OPERATING THE TRACTOR
1.25
Engage
Disengage
Fig.1
Fig.2
150005MA010302A
Hide quick links:
Advertisement
Table of Contents
