Powered Sweeper Collector - Hayter SST38/ST42 Operator's Manual

1.37

POWERED SWEEPER COLLECTOR

Replacement of the Primary Drive Belt:
- Refer to the 'Attaching/Detaching the Sweeper Collector'.
- Follow the procedure and detach the sweeper collector sufficiently to allow removal of the primary drive
belt.
- Fit a replacement drive belt and re-attach the sweeper collector as described.
Replacement of the Brush Drive Belt:
- Remove 2 M10 Nyloc nuts and plain washers and remove the plastic
side guard.
- Hold back the tensioner assembly and remove the brush drive belt.
- Fit a replacement drive belt and ensure that it is correctly routed and
tensioned.
- Replace the side guard.
- Replace the M10 fastenings and tighten securely.
Replacement of the Bristle Sections:
- Remove the hopper assembly and gain access to the brush assembly
through the rear of the sweeper unit.
- Loosen the clamps at each end of the brush stack assembly.
- Slide each brush section aside as required to enable the individual bris-
tle holder sections to be withdrawn by sliding from the location slots.
- Replace bristle sections as required.
- Slide the brush sections together until they are tightly packed in the
centre of the square shaft.
- Re-position and re-tighten the end clamps to secure the brush stack
assembly.
- Replace the hopper assembly.
MAINTENANCE
1.37
150005MA010302A