Sweeper Collector Lift Lever; Attaching/Detaching The Sweeper Collector - Hayter SST38/ST42 Operator's Manual

1.26

SWEEPER COLLECTOR LIFT LEVER

The sweeper collector can be lifted for transport and lowered into work by
means of the lift lever situated to the right of the seat.
Raising the lever will lower the sweeper collector to the ground. Allow the
lever to fall back until it rests on the front of the sweeper collector housing.
Raise the sweeper/collector into the transport position by pulling the lift
lever forwards and down until it reaches its lowest position adjacent to and
parallel with the platform.
WARNING: PREVENT ACCIDENTS - When operating the lift lever
with the sweeper collector attached to the tractor, be sure to maintain
a firm grip on the lever. Inadvertent release of the lever whilst it is in
mid-travel could cause sudden movement leading to injury.

ATTACHING/DETACHING THE SWEEPER COLLECTOR

Attaching the sweeper collector:
- Attaching the sweeper collector to the tractor will be easier if both units
are on firm, level ground.
- Raise both the tractor seat and the rear guard flap.
- Position the sweeper collector behind the tractor in line with rear lift
linkages.
- Operate the sweeper collector lift lever so as to position the lift linkage
on the tractor into its lowest position.
- Move the sweeper collector forwards, raising the hooks on the linkage
bracket so that they engage the upper pins on the tractor lift linkage
brackets (Refer fig. 1)
- Open the sweeper collector latch locking mechanism.
OPERATING THE TRACTOR
1.26
Fig.1
150005MA010302A