Use of non standard parts or any arbitrary modifications carried out on this machine may relieve Hayter Limited of liability for any resulting damage or injury. For a full range of products and to locate your nearest authorised sales stockist, service or parts dealer please visit our website at www.hayter.co.uk...
MAIN FEATURES SPECIFICATIONS Code Weight 22 kg Length 1360 mm Width 405 mm Height 1050 mm Width of Cut 360 mm Height of Cut (7 positions) 13 - 60 mm Volts and Frequency 230V / 50 Hz Power 1.4 kW Cutterblade Speed 2950 rpm Fuse Rating...
Mow only in daylight or good artificial light. operator. ensure that it is in good condition. A damaged cutterblade must be replaced immediately with a genuine Hayter replacement Avoid using the machine on wet grass, where feasible. Never mow while people, especially children, or pets are nearby.
Replace worn or damaged parts for safety. mower to and from the area to be mowed. Wear strong work gloves when removing and reassembling the Always replace worn or faulty parts with genuine Hayter parts. cutterblade. Never operate the machine with defective guards, or without This machine contains spring loaded assemblies which could safety devices, for example deflectors and/or grass bag in place.
Remove the mower from the packaging and check that the fig.4) following items have been supplied correctly. If any items are missing, contact your local Hayter dealer. Grassbag Attachment Once the grassbag is assembled. Raise the rear deflector, pass 1. Grassbag Top Cover 4.
OPERATING THE MOWER To prevent accidents do not raise the front of the mower remove all objects which when contacted by the mower Starting excessively when making a turn. Never raise the rear of the cutterblade could become dangerous projectiles. Inspect the mower when the motor is running.
OPERATING THE MOWER Heavy Growth cut area at all times. A cable which is out of sight, is out of mind discharge chute and remove any blockage. Turn the machine and this could lead to a hazardous situation. on its side and clear the obstruction from the cutterblade and Areas of heavy growth should be mown without collecting the Plan a ‘cutting scheme’...
NOT rotate tools towards the cutting edges to avoid the risk • Clean grass debris from the height of cut ratchet, air filter Securing Nuts & Bolts of injury should the tool slip. ALWAYS use genuine Hayter mesh and the underside of the deck housing. replacement parts. •...
MAINTENANCE SCHEDULE / MOWER MAINTENANCE Cutterblade Sharpening knobs to allow the top section of the handlebar to pivot forward (a) These products should not be disposed of as unsorted municipal to rest against the middle section. Unscrew the bottom two waste.
LAWN CARE CALENDAR To be used as a guide only January July Lawn Stripes There is very little work to do this month apart from brushing Treat the grass with the second application of fertiliser or weed The way to achieve a neat striped effect is for the lawn being away leaves.
Motor will not stop Faulty switch control unit Ensure that the switch lever has returned to the ‘OFF’ position. Disconnect from the mains and contact your Hayter dealer Cutterblade runs Faulty brake unit Contact your Hayter dealer on excessively after switching ‘OFF’...
If you are in doubt or experience any difficulty, please consult a Hayter Authorised Service Dealer for clarification. This warranty does not apply to any unit that has been tampered with, altered, misused, abused or used for hire, and will become invalid if non genuine Hayter parts are fitted. This warranty does not cover for minor mechanical adjustments unless they are due to defective material or workmanship.
Hayter dealer. Your personal information will be processed by Hayter in the UK. It will also be entered into the Toro warranty system, which is hosted on servers located within the United States where privacy law may not provide the same protection as applies in your country.