Reinstalling The Side Cover - Lenovo ThinkServer TS100 User Manual

Reinstalling the side cover

If you removed the bezel, reinstall it before you reinstall the side cover. See
"Reinstalling the two-piece bezel" on page 51.
Note: The rear adapter-retention bracket rests against the server side cover. You
might find it easier to lay the server on its side to replace the side cover.
To reinstall the side cover, complete the following steps:
1. Before you install the side cover, make sure that all cables, adapters, and other
components are installed and seated correctly and that you have not left loose
tools or parts inside the server. Also, make sure that all internal cables are
correctly routed.
Note: The cover-release latch 1 must be in the unlocked (opened) position
before you install the side cover.
2. Position the lip on the bottom edge of the side cover on the ledge on the
bottom of the chassis; then, rotate the cover up to the chassis, and then press
down on the cover-release latch and push the cover completely closed until it
latches securely into place.
3. Close the cover-release latch to secure the side cover in place.
4. Lock the side cover key lock 2 .
Chapter 2. Installing optional devices
53