Lenovo ThinkServer TS100 User Manual page 52

To install a simple-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all external cables
3. Unlock the side cover (the bezel will not disengage from the server if the cover
4. Remove the lower bezel (see "Removing the two-piece bezel" on page 24).
5. Touch the static-protective package that contains the drive to any unpainted
6. Align the drive assembly with the guide rails in the bay (the connector end of
7. Pull the loops of the drive assembly toward each other; then, carefully slide the
If you have other devices to install or remove, do so now; otherwise, go to
"Completing the installation" on page 51.
The simple-swap-drive backplate controls the IDs of the internal simple-swap drive
bays. The following table lists the IDs of the hard disk drives and backplate in
simple-swap models.
38
ThinkServer TS100 Types 6431, 6432, 6433, and 6434: User Guide
on page 19.
and power cords.
is locked).
metal surface on the server; then, remove the drive from the package and place
it on a static-protective surface.
the drive goes in first).
drive assembly into the drive bay until it stops, and release the loops.
Note: Do not release the loops on the drive assembly until it is completely
seated.
Table 11. IDs of simple-swap drives
Drive bay
4
ID
0