Lenovo ThinkServer TS100 User Manual page 42

The following illustration shows the dual inline memory module (DIMM)
Attention: Static electricity that is released to internal server components when
the server is powered-on might cause the server to stop, which might result in the
loss of data. To avoid this potential problem, always use an electrostatic-discharge
wrist strap or other grounding system when you work inside the server with the
power on.
To install a DIMM, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cords and
3. Remove the side cover (see "Removing the side cover" on page 23).
4. Locate the DIMM connectors on the system board. Determine the connectors
28
ThinkServer TS100 Types 6431, 6432, 6433, and 6434: User Guide
2 connectors and corresponding LEDs 1 on the system board.
on page 19.
all external cables.
into which you will install the DIMMs. Install the DIMMs in the sequence
shown in the following table.
Table 6. DIMM installation sequence
Number of DIMMs
1
2 (interleaved configuration)
3
4 (interleaved configuration)
Installation sequence (connectors)
1
1, 3
Not supported
1, 3, 2, 4