Lenovo ThinkServer TS100 User Manual page 55

v The server scans PCI Express x8 slot 1, PCI Express x4 slot 2, PCI-X slot 3, and
PCI slots 4 and 5 to assign system resources. Then, the server starts the PCI
devices in the following order, if you have not changed the default startup
sequence: PCI Express x8 slot 1, PCI Express x4 slot 2, PCI-X slot 3, PCI slot 4,
and PCI slot 5.
v For a list of supported optional devices for the server, go to:
http://www.lenovo.com/accessories.
Attention: Static electricity that is released to internal server components when
the server is powered-on might cause the server to stop, which might result in the
loss of data. To avoid this potential problem, always use an electrostatic-discharge
wrist strap or other grounding system when you work inside the server with the
power on.
See "System-board optional-device connectors" on page 16 for the locations of the
expansion slots and the systems-management Ethernet connector.
To install an adapter, complete the following steps:
1. Read the safety information that begins on page v and "Installation
guidelines" on page 19.
2. Turn off the server and peripheral devices and disconnect all external cables
and power cords; then, remove the side cover. See "Removing the side cover"
on page 23.
3. Follow the cabling instructions, if any, that come with the adapter. Route the
adapter cables before you install the adapter.
4. Follow the instructions that come with the adapter to set jumpers or switches,
if any.
5. Rotate the rear adapter-retention bracket to the open position and remove it
from the server.
Chapter 2. Installing optional devices
41