Avaya 3616 Series User Manual page 12

Avaya Inc. Avaya 3616/3620/3626 Wireless IP Telephone User Guide
any 3626 Wireless IP Telephone using the same channel. The
user can start talking immediately. The display screen shows the
current active channel.
If no transmission occurs during the ten-second countdown
period, the 3626 Wireless IP Telephone reverts to the idle state.
Receiving Upon receiving a PTT transmission, the phone plays the
"receiving alert" sound and enters the receive state.
In this state the phone receives all conversations on the selected
Talk
channel. The phone will ignore the button while in the
receive state. The screen shows the current active channel, the
caller ID information of the current transmitter, and an indication
that the phone is receiving a broadcast transmission. The caller
ID is protocol specific. In most cases it is simply the extension
number programmed in the phone from the on-hook user menu.
At the end of a transmission, the phone enters the waiting state
where it monitors the channel for up to ten seconds and displays
"Waiting" on the screen. If no other transmission occurs within
ten seconds the phone reverts to idle state.
Change PTT volume Use the
Up Down
and buttons to raise or lower PTT volume. A
separate volume is maintained for PTT calls with the current
volume selection retained in memory.
Muting a PTT call To mute a current call, press the
Mute
softkey. This brings up a
Mute Two-Way Radio? Yes No
prompt. Press the or softkey.
The prompt disappears after 3 seconds if the user doesn't confirm
Yes No
either or .
Mute only affects the current call and the phone will play
subsequent PTT calls. Mute does not allow the user to use the
Wireless IP Telephone's keypad for anything else, including an
OAI application.
Mute Unmute
The softkey turns into an softkey while in the mute
state and can be used to unmute the PTT call (the confirmation
prompt is displayed first).
When the next PTT call period starts the audio is automatically
unmuted.
Early termination of a
Terminate
In order to terminate incoming broadcasts, press the
PTT call
Yes
softkey and answer to the confirmation prompt. Push-to-talk
audio is immediately stopped and the phone exits the PTT
session. No other Wireless IP Telephone is affected. Only the
current call is terminated for this handset. When the next PTT call
period starts, the Wireless IP Telephone is again in the receive
state. You may rejoin a still-active session by initiating a PTT
call.
Users should disable the PTT feature in the on-hook user menu if
it is desired to not receive any further PTT calls.
21-300629, Issue 1, July 2005 Page 12