Battery Packs - Avaya 3616 Series User Manual

Avaya Inc.

Battery Packs

Overview The Wireless IP Telephone will need to have its Battery Pack
Indications of low
Caution: Take care not to short the battery contacts on the Battery Pack
3616, 3620 Battery Pack
removal and
replacement
Battery Pack removal
and replacement
Changing the Battery
Pack while in a call
21-300629, Issue 1, July 2005
Avaya 3616/3620/3626 Wireless IP Telephone User Guide
recharged periodically. The Nickel Metal Hydride (NiMH)
rechargeable Wireless IP Telephone Battery Pack gives you four
hours of talk time or 80 hours of stand-by time (unless PTT is
enabled in the 3626 Wireless Telephone only). Stand-by time is
when the handset is turned on, but not in an active call.
The Wireless IP Telephone will notify you when the charge on
battery
the Battery Pack is low by displaying the battery icon. If you are
in a call you will hear a soft beep through the earpiece every
thirty seconds. The user has 15–30 minutes of battery life left.
The alerts will increase to every six seconds when there is about
one minute of battery life left.
Not in call: The message Low Battery and a loud beep indicate a
critically low Battery Pack charge. These occur when the user is
not in a call. The Wireless IP Telephone will not work until the
Battery Pack is charged.
with metal objects such as coins, keys or paper clips. Shorting
the contacts can cause permanent damage.
To remove, press down on the latch on the Battery Pack on the
back of the Wireless IP Telephone. The Battery Pack releases
outward.
To replace, slide the lip of the Battery Pack into the bottom of
the cavity. Push the top of the Battery Pack until it snaps into
place. You should not have to force it against the Wireless IP
Telephone.
3626
To remove, hold the handset in one hand with the keypad facing
up. Press both Battery Pack release buttons (on the left and right
sides of the handset) at the same time. The Battery Pack will
release downward. You may catch it with the palm of your other
hand. If the Battery Pack does not release, gently shake the
handset while pressing both release buttons. Do not pry.
To replace, slide the Battery Pack straight into the cavity until it
snaps into place. You should not have to force it against the
Wireless IP Telephone.
If you are using the Telephony Gateway in your telephone
system the Battery Pack may be changed while the call is still in
progress. Do not press
Quickly remove the discharged Battery Pack and replace with a
charged Battery Pack, then press
IP Telephone back on. Press
progress.
End Call
on the Wireless IP Telephone.
Power On
to turn the Wireless
Start Call
to resume the call in
Page 18