Manual Control Level - Omron E5CN-HT User Manual

Manual Control Level

5-8

Manual Control Level

PV/MV (Manual MV)
Function
232
The manipulated variable can be set in manual mode while the PV/MV param-
eter is displayed.
The final MV used in automatic mode will be used as the initial manual MV
when moving from automatic mode to manual mode. In manual mode, the
change value will be saved immediately and reflected in the actual MV.
Power ON
Operation
Level
PF
Press the Key for
at least 1 s or the O
Key for at least 1 s.
(See note.)
Manual Control Level
M + U
Press the Keys simultaneously
for at least 1 s. (E5CN-HT)
To move from the operation level to the manual control level, press the O Key
for at least three seconds with the Auto/Manual Switch parameter displayed.
In addition, this operation can be performed using the PF Key by setting the
PF Key parameter (advanced function setting level) to A-M (Auto/Manual). For
details on the setting method, refer to 4-12 Performing Manual Control.
This setting cannot be made during ON/OFF operation.
• The MANU indicator will light during manual control.
• It is not possible to move to any displays except for the PV/MV parameter
during manual operation.
• To return to the operation level, press the O Key or the PF Key in the
manual control level for at least one second.
The manual control level display appears as shown below.
With No. 3 Display
C 25.0
100.0
50.0
MANU
PV/SP/Manual MV
Note: When the PV/SP Display Screen
Program
Setting Level
Press the O Key for
at least 1 s.
PID Setting
Adjustment
Level
Level
Press the O Key for at
a-m
least 1 s; display will flash.
Press the O Key for
at least 3 s.
Note: When PF Setting parameter is set to A-M.
Without No. 3 Display
C
25.0
50.0
MANU
PV/Manual MV
Selection parameter is 0.
Section 5-8
PF
Press the Key
for at least 1 s. (See note.)
M + U
Press the Keys
simultaneously for at
least 1 s. (E5CN-HT)
C
25.0
50.0
MANU
PV/Manual MV