Program Status Output - Omron E5CN-HT User Manual

Program-related Functions

4-15-6 Program Status Output

Program End Output
144
• If the OFF time is shorter than the ON time, the output remains ON
from when the ON time has elapsed until the next OFF condition.
• If an advance operation is executed, a time equivalent to the set pro-
gram time will be considered to have elapsed. For example, if an ad-
vance operation is executed before the ON time elapses in the above
figure, the output remains ON from the start of the next segment until
the OFF time has elapsed.
• The time signal is turned OFF under the following conditions:
• In reset status
• If one program execution has been completed when program repeti-
tions or a program link has been set
• If the Operation End Operation is set to fixed SP control and the pro-
gram ends
• If the ON and OFF times are the same
• The time signal timer stops during hold, wait, and auto-tuning operations.
• A program end output is assigned to an auxiliary output or control output.
If the program end output is not assigned, p.end and the SP will be dis-
played alternately.
• The program end output occurs at the end of the last segment.
Set point
Program end output
• The program end output occurs at the end of the last segment of the last
program execution if program repetitions or a program link is set.
• The pulse width of the program end output is set using the Program End
ON Time parameter. The setting range for the Program End ON Time
parameter is 0.0 to 10.0 s. The default is 0.0.
• If the Program End ON Time parameter is set to ON, the output will
remain ON until the Run/Reset parameter is changed to Run. If the Oper-
ation End Operation parameter is set to Reset and the power is reset or a
software reset is executed while the program end output is ON, the pro-
gram end output will turn OFF.
Last segment
Program End ON Time
Section 4-15
Time