D621 User's Guide
Extend Auto On Time (Cmd 51)
Your security company can program your system to turn on automatically. This
command allows you to delay the auto-on time by one hour during the auto-on
pre-alert time.
1.
Make sure the system is turned off (All and Part indicators are off).
2.
Press [CMD] [5] [1]. The Command Center may prompt you to
enter a valid passcode by flashing the Cmd indicator.
3.
Enter your passcode if necessary. The Command Center sounds a
valid tone.
All Areas On (Cmd 80)
Depending on the areas assigned to your authority level, this command allows you
to turn on all areas at the same time when the system is split into more than one
area.
1.
Press [CMD] [8] [0]. The Command Center may prompt you to
enter a valid passcode by flashing the Cmd indicator.
2.
Enter your passcode. If your passcode is valid, the Command Center
illuminates the All On indicator and exit delay starts.
If an area has a faulted point(s) when you try to turn all areas All On, the
appropriate Point LED illuminates (Points 1 to 16). Hold down the All On key for 2
sec. to force all areas to All On.
The Command Center lights Point Indicators 1 to 4 to indicate the areas that are
forced on. These indicators are:
• Point 1 Indicator = Area 1
• Point 2 Indicator = Area 2
• Point 3 Indicator = Area 3
• Point 4 Indicator = Area 4
46840D
I can perform this command.
I cannot perform this command.
I can perform this command.
I cannot perform this command.
D621 User's Guide
Page 40
© 2003 Bosch Security Systems