Turn the System On with No Exit Tone
Use this command to turn the entire system All On, Part On, or Part 2 On without
any exit tones. Remember that turning the system on with no exit tone eliminates
the tone emitted by the Command Center intended to alert occupants that the
system is about to arm.
This command is useful when you want to arm the system, but not disturb the
occupants while the system counts down prior to arming.
1.
Make sure all points are normal (not faulted).
2.
Press and hold the appropriate key to silence the exit tone (see Table
4). The Command Center may prompt you to enter a valid
passcode.
Arming With
All On
Part On
Part 2 On
Silencing the Exit Delay Tone doubles the Exit Delay period.
IMPORTANT
•
All On (Cmd 1) Operation: "All" and "Cmd" LEDs are on
during the Exit Delay period.
•
Part On (Cmd 2) Operation: "Part" and "Cmd" LEDs are
on during the Exit Delay period.
•
Part 2 On (Cmd 3) Operation: "Part" and "Cmd" LEDs
are on during the Exit Delay period.
The Cmd indicator turns off when Exit Delay expires.
© 2003 Bosch Security Systems
D621 User's Guide
To Silence Exit Tone
Press and hold [ALL ON].
OR
Press [CMD], then press and hold [1].
Press and hold [PART ON].
OR
Press [CMD], then press and hold [2].
Press [CMD], then press and hold [3].
Table 4: Exit Tones
D621 User's Guide
Page 19
46840D