D621 User's Guide
View Point Trouble (Cmd 48)
Use this command to view which points (if any) are in trouble.
1.
Make sure the system is turned off (All and Part indicators are off).
2.
Press [CMD] [4] [8]. The Command Center may prompt you to
enter a valid passcode by flashing the Cmd light.
3.
Enter your passcode. The Command Center displays all points that
are in trouble (if any). See Table 7.
The LED Command Center only displays Points 1 to 16.
IMPORTANT
Flashing Slow
Flashing Fast
4.
Press [CMD] twice to exit the View Point Trouble command.
46840D
I can perform this command.
I cannot perform this command.
Point
Trouble Condition
Off
No Point Trouble
On
Wiring Fault
RF Sensor Low Battery
RF Sensor Missing
Table 7: Trouble Points
D621 User's Guide
Page 32
© 2003 Bosch Security Systems