D621 User's Guide
Turn the System All On (All On or Cmd 1)
Exit Delay Time (to be filled in by your security company).
You have __________ sec. to exit premises before system turns on.
Use this command to turn on the entire system. Once you press the All On key, the
Exit Delay timer starts its countdown. Your security company programs the length
of exit delay to ensure you have adequate time to exit.
You should leave the premises before the exit time expires. Leaving after exit delay
expires starts an alarm event.
1.
Make sure all points are normal (not faulted). If your system has a
faulted point, return it to normal or bypass the point (see Bypass
Points).
2.
Press [ALL ON]. The Command Center may prompt you to enter a
valid passcode if necessary by flashing the Cmd indicator.
3.
Enter your passcode if necessary. Exit delay begins. The All On,
Status, and Cmd indicators light. You should leave at this time.
1
2
3
4
9 10 11 12 13 14 15 16
During the exit delay, you may stop the system from turning on by
entering your passcode.
If you wish, you can turn the system All On with No Delay by
pressing [NO DELAY] or you may bypass points by pressing
[BYPASS]. See Bypass Points for more information.
4.
During the last 10 sec. of Exit Delay, the Command Center emits a
double tone every second to warn you not to exit and to turn the
system off. The system then turns All On. The All On indicator
remains on steady.
5.
To turn the system off, enter your passcode.
46840D
I can perform this command.
I cannot perform this command.
5
6
7
8
D621 User's Guide
Page 14
All
Status
Part
Cmd
© 2003 Bosch Security Systems