System Test (Cmd 41); Table 8: System Test Lights - Bosch D621 User Manual

System Test (Cmd 41)

The System Test command allows you to ensure your system is operating correctly
by testing the system's bell, strobe, battery, and phone line. Only those
programmed by your installing security company are tested (your system may
only be programmed to test the back-up battery and the bell output).
If any of these components fails to test, contact your security company for
assistance. Be sure to contact your security company before you begin the system
test.
1. Make sure the system is turned off (All and Part indicators are off).
2. Press [CMD] [4] [1]. The Command Center may prompt you to
enter a valid passcode by flashing the Cmd indicator.
3. Enter your passcode if necessary. The system starts the test. As each
test is underway, the corresponding point indicator lights. See Table 8.
Point # Testing
1 Bell
2 Strobe (may take up to 20 min.)*
3 Backup Battery (may take 4 min.)*
4 Communications (may take up to 10 min.)*
* To skip to the next text, press the [*] key.
When testing the bell and strobe, check for bell/strobe activation. The
LED testing status does not indicate bell/strobe test failure (point
indicator does not flash fast upon test failure).
IMPORTANT
© 2003 Bosch Security Systems
D621 User's Guide
I can perform this command.
I cannot perform this command.
I can test:
System Bell Battery
System Strobe Phone Line

Table 8: System Test Lights

D621 User's Guide
Page 33 46840D