Set Part 2 Points (Cmd 65) - Bosch D621 User Manual

Set Part 2 Points (Cmd 65)

Use this command to select which points are armed when you turn the system Part
2 On. This allows you to turn part of the system on to detect intrusion, while the
remaining part of the system allows you to move freely without sounding an
alarm.
1. Make sure the system is turned off (All and Part indicators are off).
2. Press [CMD] [6] [5]. The Command Center may prompt you to
enter a valid passcode by flashing the Cmd indicator.
3. Enter your passcode if necessary. The Command Center indicates
which points are available for selections. Points that are on steady are
selected for Part 2, flashing points are available for selection.
4. Enter the Point Number you want to activate or deactivate for Part 2
On followed by the [*] key. Repeat this step until all points have been
designated Yes or No for Part 2 Mode (Yes = Active, ready to detect
intrusion; No = Non-Active, you can move freely without sounding
an alarm).
1 2 3 4
9 10 11 12 13 14 15 16
5. Press [CMD] to exit this command.
© 2003 Bosch Security Systems
D621 User's Guide
I can perform this command.
I cannot perform this command.
5 6 7 8
D621 User's Guide
Page 17
All Status
Part Cmd
46840D